Characterization of the ECN spray A in different facilities. Part 1: boundary conditions characterization - IFPEN - IFP Energies nouvelles Access content directly
Journal Articles Oil & Gas Science and Technology - Revue d'IFP Energies nouvelles Year : 2020

Characterization of the ECN spray A in different facilities. Part 1: boundary conditions characterization


The Engine Combustion Network (ECN) community has greatly contributed to improve the fundamental understanding of spray atomization and combustion at conditions relevant to internal combustion engines. In this context, standardized spray experiments have been defined to facilitate the comparison of experimental and simulation studies performed in different facilities and with different models. This operating mode promotes collaborations among research groups and accelerates the advancement of research on spray. In efforts to improve the comparability of the ECN spray A experiments, it is of high importance to review the boundary conditions of different devices used in the community. This work is issued from the collaboration in the ECN France project, where two new experimental facilities from PPRIME (Poitiers) and PRISME (Orleans) institutes are validated to perform spray A experiments. The two facilities, based on Rapid Compression Machine (RCM) design, have been investigated to characterize their boundary conditions (e.g., flow velocity as well as fuel and gas temperatures). A set of standardized spray experiments were performed to compare their results with those obtained in other facilities, in particular the Constant Volume Pre-burn (CVP) vessel at IFPEN. It is noteworthy that it is the first time that RCM type facilities are used in such a way within the ECN. This paper (part 1) focuses on the facilities description and the fine characterization of their boundary conditions. A further paper (part 2) will present the results obtained with the same facilities performing ECN standard spray A characterizations. The reported review of thermocouple thermometry highlights that it is necessary to use thin-wires and bare-bead junction as small as possible. This would help to measure the temperature fluctuations with a minimal need for error corrections, which are highly dependent on the proper estimation of the velocity through the junction, and therefore it may introduce important uncertainties. Temperature heterogeneities are observed in all spray A devices. The standard deviation of the temperature distribution at the time of injection is approximately 5%. We report time-resolved temperature measurement from PPRIME RCM, performed in the near nozzle area during the injection. In inert condition, colder gases from the boundary layer are entrained toward the mixing area of the spray causing a further deviation from the target temperature. This emphasizes the importance of the temperature in the boundary (wall) layer. In reacting condition, the temperature of these entrained gases increases by the effect of the increased pressure, as the RCM has a relatively small volume. Generally, the velocity and turbulence levels are an order of magnitude higher in RCM and constant pressure flow compared to CVP vessels. The boundary characterization presented here will be the base for discussing spray behavior in the part 2 of this paper.
Fichier principal
Vignette du fichier
ogst190284.pdf (7.76 Mo) Télécharger le fichier
Origin : Publication funded by an institution

Dates and versions

hal-02813373 , version 1 (06-06-2020)



Moez Ben Houidi, Camille Hespel, Michele Bardi, Ob Nilaphai, Louis-Marie Malbec, et al.. Characterization of the ECN spray A in different facilities. Part 1: boundary conditions characterization. Oil & Gas Science and Technology - Revue d'IFP Energies nouvelles, 2020, 75, pp.35. ⟨10.2516/ogst/2020023⟩. ⟨hal-02813373⟩
146 View
107 Download



Gmail Facebook X LinkedIn More